Showing posts with label bobbin case. Show all posts
Showing posts with label bobbin case. Show all posts

Wednesday, July 13, 2011

201 Bobbin Case & Retaining Ring Re-Installation


First we covered How to remove the bobbin case, then we went over How to remove and replace the rotating hook assembly. Now that we've got the hook assembly area nice and spiffy, time to get everything back together. You may have heard that it's difficult to get the bobbin case and retaining ring back together, but you're going to be thrilled with how easy this is. First, put a drop of oil in the hook assembly, on the little track where the bobbin case will ride.


Tuesday, July 12, 2011

How To Remove a 201 Bobbin Case

Taking the bobbin case out of a 201-2 is simple. Dead simple. These instructions look long, but you'll only have to follow along with them once or twice. After you do this a couple times, it'll be as easy as removing the gas cap on your car.

You will need the correct tools: A screwdriver with good bits, and the small, silver Singer screwdriver (pictured up top) that came with many machines.

If you don't have the Singer screwdriver, find the tiniest flathead (slotted) screwdriver you can find. To see if it's the right size, take out a dollar bill. See those letters at the top of the bill that say FEDERAL RESERVE NOTE? The width of the screwdriver blade's edge should be about the same height as those letters, as seen in the photo below. If it's much smaller or bigger than the letters, it will probably not work. (Update: If you don't have U.S. money to check with, click here.)